PhotoSpin Pro User’s Manual 1: Setup and Menus

HUD

Chat Interface

Settings

PhotoSpin Pro allows you to customize the Users Allowed, Channel, and Chat Channel settings according to your preferences. Each of these settings is stored inside the Control Sphere as a notecard. Follow these steps in order to view or alter the settings:

  1. Edit the PhotoSpin Pro Control Sphere.
  2. Click the Content tab. You will see several note cards with names beginning with the # sign. These are the settings note cards.
  3. To change a setting, right-click it and select Rename from the menu. Change the text after the equals sign to whatever value you would like, respecting the limits applicable to that particular setting (see below). Press Enter when you are done to save the setting’s new value.
  4. Wait a few seconds for PhotoSpin Pro to apply the changed setting.

Important: Do not rename or change in any way the text between the # sign and the equals sign in a setting. Also, don’t leave any blanks to either side of the equals sign. If you do this, the setting will not be interpreted correctly by PhotoSpin Pro.

The next sections describe each setting that is supported by the PhotoSpin Pro.

UsersAllowed

This setting controls who can use your PhotoSpin Pro. Possible values are the following:

  1. All – Anybody can use the PhotoSpin Pro.
  2. Group – Only active members of the same group, plus the owner, can use the PhotoSpin Pro.
  3. Owner – Only the PhotoSpin Pro owner can use it.

If this setting is not specified, or a value other than the above listed ones is used, then by default PhotoSpin Pro will allow anybody to use it.

Channel

This setting controls which communications channel is used by the Control Sphere to talk to the backdrop, lights, effects and gazers. Possible values are numbers between (and including) 1 and 9.

If this setting is not specified, or a value other than the above mentioned is used, channel 1 is assumed by default.

If you change the channel number for the Control Sphere and Backdrop, you will also need to change the channel number for the HUD. To do this, follow these instructions:

  1. Locate the PhotoSpin HUD in your inventory and rez it inworld.
  2. Edit the HUD and click the Content tab.
  3. Right-click the Channel notecard, select Rename, and enter the new channel number.
  4. Wait a few seconds for the HUD to apply the new setting.
  5. Take the HUD back into your inventory.

Note: the Control Sphere also contains a HUD which it delivers when you click Options>Get HUD. If you change the channel number, it is advisable to replace the HUD in the Control Sphere with the new one. To do this:

  1. Edit the Control Sphere and click the Content tab.
  2. Locate the existing PhotoSpin Pro HUD (object) in the list of contents and delete it.
  3. Locate the HUD with the new channel number in your inventory.
  4. Drag the new HUD from your inventory and drop it into the Contents folder.

ChatChannel

This setting controls which communications channel is used by the PhotoSpin Pro to listen to your chat commands. Possible values are numbers between (and including) 80 and 89.

If this setting is not specified, or a value other than the above mentioned is used, channel 81 is assumed by default.

top

Introduction & Quick Start

Setting Up PhotoSpin Pro

Main Menu and Options

Backdrop

Green Screen

Organizing Textures

Lights

Effects

Gazers

Easy Touch

Saving Configurations

Settings

Support

Usage Agreement

Advertisements

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14


%d bloggers like this: